New Table Saw Fence – Part 1

Published on by Mike

Back in September of 2010, before I had even thought of starting a blog, I did a write up on one of the woodworking forums about installing the Delta T-2 Fence on my Craftsman Contractor saw.  With what I am trying to accomplish on my Blog, I thought it would be relevant to repost it here.   I have revised and cleaned up each post so that it fits better in a blog setting, as well as make the dates and timelines appropriate.  The photos are not the best, and often dark.  Since I did this install, I have gotten a better camera and the lighting in the garage/shop area has been improved.

Originally Posted On September 7th, 2010

As mentioned in the safety thread, I ordered a Delta T2 36-T30 fence system for my 25 year old Craftsman Contractor saw. I bought a Craftsman Contractor table saw for $100 via craigslist earlier in 2010, and overall was happy with the saw, except the fence was stock as it was shot. (please note, I had no expectations at getting an older table saw with a good fence at the time of purchase) As much as I would have liked a Biesemeyer or Incra fence, the T2 @ $155 (that is including shipping) it seemed liked a smart purchase for the saw.

I am breaking this down across multiple posts so that I can better show and explain the overall process, especially since there is a few challenges to installing a Delta fence to Craftsman table saw.

The first picture is the before picture. As you can see the fence would only go right of the blade. Honestly it wasn’t that big of a limitation, but there are times when having the fence to the left of the blade is useful. Also the power switch points down towards the floor, which can make it hard to get to when trying to turn the saw off. The second picture has all the T2 Fence parts laid out for inspection.

original_fence new_fence_unboxed

Leave a Reply