Haven’t figured out where I am going to hang it yet, but today I sharpened all the chisels, put some oil on them, and put them in their permanent home!
Category: Chisel Rack
Chisel Rack With a Couple Coats of Shellac
Published on by Mike (Leave a comment)
The coats of shellac have been applied, and I very lightly sanded the last coat with 400 grit sand paper. The result is a finish that has just the right amount shine to it. In fact if it is in the right light, you can see a little bit of a reflection in the finish! The last picture was taken with the flash, and you can see some of that reflection happening! I did cut up a foam rubber mouse pad, and covered the bottoms of each slot with that so that will help protect the sharp edge of the chisel. The rack itself is basically complete now. The next step is to sharpen and hone all the chisels going into it, and to of course, find a place on the wall to hang it! Will take and post pics once that has been completed as well.
Chisel Rack with Boiled Linseed Oil
Published on by Mike (Leave a comment)
Today, I applied Boiled Linsee Oil to my project. I am very happy with with how it turned out so far! Next I will be spraying on a few coats of Shellac.
Chisel Rack Project
Published on by Mike (Leave a comment)
The chisel rack is completely glued together, and I spent quite a bit of time with hand planes and scrapers working on getting all the edges and glue joints as smooth as possible. The next step from here is to start the finish process. Will put further updates on here with how that goes.
Chisel Collection Update & Current Project
Published on by Mike (Leave a comment)
I know it has been awhile since I last updated, but I have been busy make sawdust!! I am happy to say that the chisel collection is now complete! The last picture you saw, there were only 3 chisels. I am happy to say I now have the complete set at 11 chisels! There were a couple of factors into why I opted to get the complete set. The biggest factor is cost. The local woodcraft had a 25% off sale for all chisels, which started AFTER I bought the first 3 pictured in the earlier post. Except for those 3, I was able to take advantage of that sale for the remaining chisels. Thankfully the sale ran for awhile! The other reason was after some coaxing from a few people on TheWoodWhisperer.com chat room (you know who you are) they convinced me it is better to have them all and use them occasionally, and not have it and need it. Surprising, I have found I have used all the chisels, fairly frequently while working on the current project, which has had a lot of hand work on it. Fyi, the chisel have been great, I would give them a 5 star rating.
The project I am working on is a storage rack for the chisels. This started out with a drawing I made in sketch-up. From the sketch-up drawins, I estimated the amount of wood I would need. I ended up buying 7 board feet of cherry for the rack. This was 2 more than I figured I would need, however I ended up using ever bit of it! Most of the longer dados were done on the router table. A lot of them were stopped short, and the squared up with my chisels. The short dados on the bottom piece were done largely by hand with the only power tool being the drill press to hog out most of the material. All the mortises were done by hand, again using the drill press to hog out much of the material. The back panel is a glue up of two smaller boards. I had the foresight to glue them together at 3/4″ thick, and let them acclimate awhile. Sure enough, I got warpage. I used, for the first time, my jack plane to get the wobble out, then planed it down to the 1/2″ thickness. The pictures below are all the parts needed to assemble the rack. Each piece has been sanded to 220. The next step is assembly, which as of this posting is not done yet. I will make a future post of the assembled rack.
